Current position >About Us
1. How to pronounce amp
The pronunciation of amp is/æ mp/.
1. Definition: Ampere, ampere (unit of current). Noun: abbreviation for amplifier, amplifier.
2. Complex numbers: amps.
III. Definition in English the basic unit of electric current adopted under the system International unites.（ The basic unit of current used is the International System of Units. ）
4. amp related phrases
1. Amperes law: a law that describes the magnetic field generated by current in a conductor.
.2. milliampere: a unit of current, where 1 milliampere is equal to 0.001 ampere.
.3. amp clamp: A tool used to measure current by clamping it onto a wire to measure the current passing through it.
.4. amp meter: An instrument used to measure current, also known as an ammeter.
5. amp rating: The maximum current that a device or component can withstand.
. Example sentence:1. Use a 3 amp fuse for equipment up to 720 watts. ）
2、This type of relay is used to switch currents greater than a few amps and power levels of several hundred to several thousand watts.（ This type of relay is used to switch currents greater than a few amperes, with power ranging from several hundred watts to several kilowatts. ）
3、A fuse holder is mounted on the back panel and contains a3 amp fuse to protect the electronics in case of a power problem.（ The fuse holder installed on the back of the panel contains a 3-amp fuse that can protect the electronic module in case of power supply issues. ）
4、An Important Problem in Measuring Input Resistance of Small Signal AMP.（ A noteworthy issue when measuring the input resistance of a weak signal amplifier. ）
5、And we thought it had something to do with this protein called AMP kinase, an energy protein.（ We believe it is related to a kinase protein called AMP, an energy protein. ）
2. How to use a clamp multimeter?
1. The use of the clamp shaped 266CLAMPMETER multimeter for measuring current: Before measurement, the rubber insulation of the clamp shaped iron core should be checked for integrity.. The jaws should be clean, rust free, and have no obvious gaps when closed. When measuring, the magnitude of the measured current should be estimated first and an appropriate range should be selected. If it is impossible to estimate, you can first choose a larger range and then gradually reduce it to the appropriate gear. When shifting the range gear, it must be done without charging or with the jaws open to avoid damaging the instrument. Pull the wrench to open the jaws and place the predicted wire in the middle. When measuring, the measured wire should be placed in the middle of the jaws as much as possible. If there is any noise on the joint surface of the jaws, it should be opened and closed again. If there is still noise, the joint surface should be treated to ensure accurate reading. Additionally, it is not allowed to clamp two wires at the same time. When measuring currents below 5A, in order to obtain more accurate readings, if conditions permit, the wire can be wound a few more times and placed in the clamp for measurement. The actual current value should be the instrument reading divided by the number of wires placed in the clamp. Before and after each measurement, the switch for adjusting the current range should be set to the highest gear to avoid damaging the instrument due to measuring without selecting the rang